RESUMEN
Se evaluó el efecto de la entrada de calor generada por el proceso de soldadura GMAW y gas protector 90Ar-10CO2 en la tenacidad a la fractura de las diferentes zonas de soldadura en juntas de acero ASTM A572 Gr 50, el cual es un acero de alta resistencia y baja aleación (HSLA). Inicialmente se realizó la caracterización del metal base a través de técnicas, como: espectrometría de emisión óptica, microscopia óptica, ensayos de tracción, ensayos de dureza y ensayos de tenacidad a la fractura, con estas se obtuvieron datos de composición química, microestructura, esfuerzo de fluencia, dureza y valores de tenacidad a la fractura, respectivamente. Posteriormente, se llevó a cabo la soldadura de las placas de acero de 400mmX150mmX6,35mm, mediante GMAW, utilizando diferentes entradas de calor (alta y baja). A partir de los cupones soldados, se identificaron las diferentes zonas de soldadura mediante macrografía; y se identificaron las fases en dichas zonas mediante metalografía y difracción de rayos X. Luego se realizó el ensayo de tenacidad a la fractura en probetas con la pregrieta ubicada en la zona afectada térmicamente (ZAT) y en la zona del metal de soldadura, de las juntas soldadas. Se evidenció que la tenacidad a la fractura está correlacionada con los cambios microestructurales en el acero ASTM A572 Gr 50 producto de los aportes térmicos del proceso de soldadura GMAW, esto tiene un impacto en las fases resultantes; así como el tamaño, ubicación y composición de los precipitados.
ABSTRACT
The effect of the heat input generated by the GMAW welding process and protective gas 90Ar-10CO2 on the fracture toughness of the different welding zones in the joints of ASTM A572 Gr 50 steel, which is a high-quality steel, was evaluated. High strength and low alloy (HSLA). Initially, the characterization of the base metal was carried out through techniques such as: optical emission spectrometry, optical microscopy, tensile tests, hardness tests and fracture toughness tests, with these data on chemical composition, microstructure, stress creep, hardness and fracture toughness values, respectively. Subsequently, the welding of the 400mmX150mmX6,35mm steel plates was carried out, by means of GMAW, using different heat inputs (high and low). From the welding coupons, the different welding zones were identified by macrography; and the phases in said zones were identified by means of metallography and X-ray diffraction. Then the fracture toughness test was carried out on specimens with the pre-crack located in the thermally affected zone (HAZ) and in the weld metal zone, welded joints. It was evidence that the fracture toughness is correlated with the microstructural changes in the ASTM A572 Gr 50 steel product of the thermal inputs of the GMAW welding process, this has an impact on the resulting phases; as well as the size, location and composition of the precipitates.